CRITICAL:  Read these instructions completely before doing anything to your car. You will need the following tools: Philips head screwdriver

Begin by removing the Cupholder-Coinholder.  It is held in place with one Phillips screw in the floor of the storage bin.  The screw may or may not be hidden under a piece of carpet on the floor of the storage section.  Some cars have carpeting, some do not.  Remove the screw.  

Pull up at the rear of the unit, and then slide the unit back in the car.  There is a plastic tab in the front of the Cupholder-Coinholder directly behind the hazard light button that mates to a slot in the center console.  The tab must be clear of the slot before the unit can be removed.  After the Cupholder-Coinholder is removed and the center console is completely empty, you can begin to install the Mark2 Armrest.

The front edge of the coinholder-cupholder has a plastic tab. This tab mates with a slot that is in your center console behind the hazard light button. Drop the front edge of the coinholder-cupholder in before the back edge. Make sure the tab on the coinholder-cupholder goes into the slot on your center console. After the tab is mated, drop the back edge of the coinholder-cupholder down into the recess in your center console. The unit will sit flush.

Tab on front edge of Coinholder-Cupholder

A properly installed Mark2 Armrest will look like this:

Coinholder-cupholder should sit flush on center console

It is critical that the armrest sits flush with the center console. Open the Mark2 Armrest and expose the storage area. If the storage area of your coinholder-cupholder has a carpeted floor, remove the carpeting. There is one philips head screw that fits into a hole on the floor of the storage area. Install the screw. You're done!

Screw location under carpet of storage area